Trine 018-2 WIRELESS TRANSMITTER Instruction Sheet And Troubleshooting Manual

018-2 WIRELESS TRANSMITTER
INSTRUCTION SHEET AND TROUBLESHOOTING GUIDE

018-2 Two Button Transmitter

• 6561 security codes available
• LED indicates operation
• Belt clip key ring provided
CAUTION:
CHANGES
017TDC2, 017TDC-3 AND 018-2 NOT EXPRESSLY APPROVED
BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD
VOID THE USERS AUTHORITY TO OPERATE THE DEVICE.
NOTE: BOTH PUSH BUTTONS ON THE 018-2 WILL TRIGGER THE 017TDC-2

SECURITY CODE SETTING:

You need to set the security codes for the 017TDC-2 or 3 receiver and the 018-2 transmitter for
security purposes.
The security code positions for the receiver must match the codes of the transmitter or
transmitters for these devices to communicate properly. (see Figure 2 below as an example)
To change the codes on your 018-2 loosen the transmitter's assembly screw and snap the front
cover open. Match the coding of the receiver. Figure 1 below shows the location of the DIP
switches for the 017TDC-2 & 3 receiver and the 018-2 transmitter.

017TDC-3 SWITCHING MODE SETTING:

The 017TDC-3 has two relays capable of being triggered together by one button from the 018-
2 transmitter or separately by the two buttons from the 018-2 transmitter. Set the relay control
switch to your desire mode by following the coding shown on the next page.
NOTE:
The 017TDC-2 has only one relay and is
triggered by any of the two buttons on
the 018-2 transmitter.
1440 Ferris Place Bronx
• Operates on 315 Mhz
• A-23 Battery Included
• FCC, IC Approved
OR MODIFICATIONS
FIGURE 1
SECURITY
CODE SWITCHES
New York 10461
TO

EXAMPLE CODE SETTING:

"B" BUTTON
THE
018-2 REMOTE
FIGURE 2
MUST BE
THE SAME
SWITCH COMBINATION
"A" BUTTON