Sanyo DC-PT70 Service Manual page 5

SERVICE MODE
4. Setting REGION code
4.1 While a highlighted indicator is displayed on the right side
of the Region denotation, push ENT,
on the remote controller. With each push the indicator will
advance as shown below.
1 <-> 2 <-> 3 <-> 4 <-> 5 <-> 6
4.2 Set up the region coder currently displayed on the set.
4.3 Once the desired number is displayed, push p button to
move the highlighted indicator to Exit area.
5. Saving settings
5.1 Make sure that the Market and Region settings are properly
set.
(If any of the settings are incorrect, you can make a change
by moving the indicator using o button, and following
procedures 3 and 4 above. )
5.2 After ensuring that the settings are all correct, push ENT
button while the indicator is on Exit area. The settings are
now saved.
6. Finishing settings
6.1 After a few seconds, the Internal Setup screen disappears,
and then the Service Mode screen is displayed again for
three seconds as shown on the right.
You should check the settings.
Backend version
Brand (S : SANYO , F : FISHER)
Version ( 2 0 0 2 . 12 . 25)
Sub Version (A,B,......Z)
Region ( 0 : Region undefined
1 ~ 6 : Region defined )
Loader Version (17 Z09 Y03)
6.2 Power OFF.
and each button
S 31204 A 2
- 4 -
Internal Setup
Market 00
1
Region 1
00-WM 01-SFC 02-UK 03-XE 04-S18
05- SS 06-PA 07-AU 08-CN 09-JP
10-FXE 11-MX 12-NT
3
The sample of a display of a region
code.
Internal Setup
Market 00
Region 1
00-WM 01-SFC 02-UK 03-XE 04-S18
05- SS 06-PA 07-AU 08-CN 09-JP
10-FXE 11-MX 12-NT
Region 2 Market
BackendVersion S 31204A2
Loader Version
Exit
(Reference figure)
Exit
(Reference figure)
17 Z09 Y03
Value
(Reference figure)