Program The Timer - Kenmore 625.348670 Owner's Manual

SECTION 1
1C.
salt level
FIG. 1
adjust button
Kenmore Water Line
for Customer Assis-
tance
1- - 800- - 426- - 9345
signal light
adjust button
on/off button
When the transformer is plugged in, the model code
HF32, and a test number (example: A2.0) show in the
faceplate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
1
NOTE:
If HF-- shows in the display, press the UP
DOWN button until HF32 shows. Then, press
the #1 SELECT button to set, and change to the
flashing PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again. If other than HF32
shows, see page 19 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals a
change in the faceplate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness (step
2), the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest
hardness setting using the UP button.

PROGRAM THE TIMER

ON/OFF- -HOLD button
low salt
(Recharge Tonight--Now)
indicator
ON/OFF
HOLD
LOW SALT
SALT
LEVEL
ADJUST
SIGNAL
LIGHT
ADJUST
TANK
LIGHT
display
tank light
SALT SIGNAL
LEVEL LEVEL
8
7
6
PRESENT TIME
5
4
3
2
1
WATER SOFTENER START-UP
#1 SELECT
button
RECHARGE TO-
NIGHT
RECHARGE NOW
SELECT
1
SELECT
2
#2 SELECT
button
1. SET PRESENT TIME OF DAY:
NOTE:
If the words¼ PRESENT TIME do not show in
the display, press the #1 SELECT button (FIG. 1)
AM
until they do, or see the notes above.
n Press the
present time. Press UP to move the display ahead;
press DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
or
If the present time is between
midnight and noon, be sure AM
shows.
NOTE:
Each press of the UP/DOWN
buttons changes the time by 1
minute. Holding the buttons in
changes the time 32 minutes each
second.
2. SET WATER HARDNESS NUMBER:
Press the #1 SELECT button once to display 25
n
(flashing) and HARDNESS.
The grains per gallon (gpg)
hardness of your water supply is
on your water analysis report. Be
sure to enter water test results on
page 2, for future reference.
6
UP button
Genius II Water Softener
DOWN button
UP/DOWN buttons to set the
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
1
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
1
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
1
PM
PRESENT TIME
AM
PRESENT TIME
HARDNESS