Kenmore 420 Series Owner's Manual page 26

The QuickCharge option is an integral part of the
IntelliSoft water and salt saving system. When this
option is selected, the softener will automatically
recharge if 95% of capacity has been unexpectedly
used and there is less than 1/2 gpm flow. The recharge
will last 30 minutes and give the softener approximately
5,000 grains capacity. The softener will also run through
a normal recharge cycle that night. Move the black bar
over On or Off and press SELECT. Display will return to
Salt Options menu, press SELECT once more to return
to normal operating screen. A "Q" will be displayed on
the normal operating screen if this option is chosen.
The QuickCharge option is ON when the softener
leaves the factory.
Rinse Option has three choices.
WaterSaver reduces by 20% the amount of water used
during regeneration. This option should only be used if
feed water is from a municipal supply, 8 grains of hard-
ness maximum, and no iron present. At Normal setting
the softener operates at normal water usage for regen-
erations, and Clean Feature adds an extra backwash
and fast rinse in the regeneration cycle. Clean feature
may be used when feed water has higher sediment or
iron content. Default setting is "Clean". Move the black
bar over choice and press SELECT. Display will return
to Salt Options menu, press SELECT once more to
return to normal operating screen. A "W" or "C" will be
displayed on the normal operating screen if WaterSaver
or Clean Feature option is chosen.
Recharge Count keeps track of the number of
recharges, either from initial set up, or since last reset.
Use the UP or DOWN arrows to move the black bar
over Yes or No and press SELECT. On the "More"
screen, Avg. Salt/Rchg is reset to 0 also, if yes is
selected. Display will return to Salt Options menu,
press SELECT once more to return to normal operating
screen.
UNITS:
Choices are 12/24 Hour Clock, Gallons/Liters,
Grains/PPM and Pounds/Kilograms.
12/24 Hour Clock option allows you to choose how the
time is displayed on the normal operating screen. Move
the black bar over 24 Hour or 12 Hour and press
SELECT. Display will return to Units menu, press
SELECT once more to return to normal operating
screen. If 12 Hour clock is chosen, an AM or PM will be
displayed, be sure that time is correctly set for AM or
PM.
26
Faceplate Timer Features
Questions? Call The Kenmore Water Line 1-800-426-9345
Salt 5:39
Q
PM
@
0.0 gpm
More
A
Water Flow
Salt
5:39
W
PM
@
0.0 gpm
More
A
Water Flow
UNITS
12 / 24 Hour Clock
Gallons / Liters
Grains / PPM
Pounds / Kilograms
Back
Exit
CHANGE SELECT
b d
FIG. 46
FIG. 47
FIG. 48