Kenmore 300 Series Owner's Manual page 8

Plug the softener transformer
into an inside, 120 volt 60Hz
electrical outlet. If an outside
outlet is used, be sure it has
approved weather protection.
DRAW IN YOUR PIPES
AND FITTINGS
Draw the plans for your "IN" and "OUT"
piping here. Include all pipe, fittings and
accessories you will use.
Make a list of all materials you will need
and buy them before you begin to install
the water softener.
8
Plan Your Installation
Suggested Slab Foundation Installation
water heater
outside
-soft
WATERSOFTENER
(install in garage, car port,
or other sheltered area)
Run drain tubing to laundry tub or
p-trap inside home, if possible.
Otherwise, run to a dry well.
Left
120V - 60Hz
Electrical
Outlet
Valve Outlet Side
Questions? Call The Kenmore Water Line 1-800-426-9345
outside
- hard
kitchen
bathroom
bypass
valve
outside
-soft
Valve Inlet
For outside hard
water, trench under-
ground as needed.
outside
- hard
water in
Your House Main Water Pipe
Right
* In what direction does the water flow?
Be sure to plan "IN" and "OUT" piping so water
flow is to the softener valve inlet. Plan a
crossover if flow is from left to right.
CROSS-OVER
Main Water Pipe
Raw Water
Inlet
Outlet
To Water Softener
FIG. 4
Soft Water
FIG. 5