Cpu Installation - MSI Super Q965 User Manual

MS-9643 Mainboard

CPU Installation

When integrating a Pentium 4 processor-based system, be sure to take the proper
electrostatic discharge (ESD) precautions. Consider using ground straps, gloves, ED
mats, or other protective measures to avoid damaging the processor and other
electrical components in the system.
Do not touch socket sensitive
contacts. W e assume no re-
sponsibility for the potential dam-
ages caused by this action and
therefore the warranty we provide
may be invalid.
Note: In order to boot up with a newly installed CPU, AC Power must be
switched off before installation.
n
Disengage Load Lever by depressing down and out on the hook to clear
retention tab. Rotate Load Lever to fully open position at approximately 135°
n
Rotate Load Plate to fully open position at approximately 100°. Remove Socket
Protective Cover. With left hand index finger and thumb to support the load plate
edge, engage protective cover finger tab with right hand thumb and peel the
cover from LGA775 Socket while pressing on center of protective cover to
assist in removal.
n
Locate two orientation key notches.
n
Grape processor with thumb and index finger. (Grasp the edges without the
orientation notches.) The socket has cutouts for your fingers to fit into. Carefully
pace the package into the socket body using a purely vertical motion. (Tilting the
processor into place or shifting it into place on the socket can damage the
sensitive socket contacts.)
n
Verify that package is within the socket body and properly mated to the orienta-
tion keys
2-4