Troubleshooting; Storage And Cleaning - Fellowes L80-95 Quick Start Manual

TROUBLESHOOTING

Problem
No 'power on' lamp (red LED)
No 'ready' lamp after a long
period (green LED)
Pouch does not completely seal
the item
Pouch has waves or bubbles
Pouch is lost in the machine
Jamming
Pouch is damaged after lamina-
tion
STORAGE & CLEANING
Switch off the machine at the wall. Allow the machine to cool. The outside of the machine can be cleaned with a damp
cloth. Do not use solvents or flammable materials to polish the machine. Cleaning sheets can be purchased for use with
the machine. When the machine is warm – run the sheets through the machine to clean any residue off the rollers. For
optimum performance, it is recommended that cleaning sheets are used with the machine regularly. (Cleaning sheet
order code #5320603).
PRODUCT REGISTRATION / WORLDWIDE WARRANTY
Thank you for purchasing a Fellowes product. Please visit www.fellowes.com/register to register your product and
benefit from product news, feedback and offers. Product details can be found listed on the rating plate positioned on the
rear side or underside of the machine. Fellowes warrants all parts of the laminator to be free of defects in material and
workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the
defective part. This warranty does not apply in cases of abuse, mishandling or unauthorized repair. Any implied warranty,
including that of merchantability or fitness for particular purpose, is hereby limited in duration to the appropriate
warranty period set forth above. In no event shall Fellowes be liable for any consequential damages attributable to
this product. This warranty gives you specific legal rights. You may have other legal rights that vary from this warranty.
The duration, terms and conditions of this warranty are valid worldwide, except where different limitations, restrictions
or conditions may be required by local law. For more details or to obtain services under this warranty, please contact
Fellowes or your dealer.
6
407534C M1-95.indd 6
Possible cause
Machine not switched on
Machine is in a hot or humid area
Item may be too thick to laminate
Temperature setting may be
incorrect
Pouch is jammed
Pouch was used 'open end' first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
Damaged rollers or adhesive on
rollers
Solution
Switch on machine at the side and at the
wall socket
Move the machine to a cooler and dry area
Check pass through thickness is correctly
selected and pass through again
Check pouch thickness is correctly selected
and pass through again
Press release lever and pull out the item
by hand
Pass cleaning sheets through the machine
to test and clean rollers
4/23/13 1:12 PM