Grundig Scenos UMS 6400 DVD Manual page 23

SETTINGS
- - SPEAKER SETUP PAGE - -
DOWNMIX
s
CENTER ON
REAR OFF
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
S
CENTER SPEAKER ON
- - SPEAKER SETUP PAGE - -
DOWNMIX
CENTER
REAR
– – 5MS
SUBWOOFER
– –
s
CNTR DELAY
– – 3MS
– –
REAR DELAY
– – 1MS
TEST TONE
– – OFF
S
CENTER DELAY SET TO 3 MS
- - SPEAKER SETUP PAGE - -
DOWNMIX
CENTER
REAR
SUBWOOFER
CNTR DELAY
ON
REAR DELAY
OFF
s
TEST TONE
S
LEFT
____________________________________________________________________________________
3 Change back to the left column with » « and use » « or » « to select
»CENTER«.
4
Change to the right column with » «, use » « or » « to select »ON« and
confirm with »DEMO/OK«.
5
Switch back to the left column with » « and make the same setting for
»REAR« and »SUBWOOFER«.
Setting the distance to the listening position
In a home entertainment system, the surround loudspeakers are usually posi-
tioned closer to the viewer than the front loudspeakers. The sound is therefore
electronically delayed by fractions of a second. This compensates for the time it
takes the sound to travel.
You should therefore measure the distances from the central speaker and the
surround speakers to the listener's central position and enter them in the relevant
menu. Enter the travel time of the sound in milliseconds (MS) (1 m corresponds
to 3 MS). »OFF« is the default value.
1 Select »SPEAKER SETUP« with » « or » « and confirm with
»DEMO/OK«.
2
Select »CNTR DELAY« (for the central loudspeaker) with » « or » «.
3
Switch to the right column with » « and use » « or » « to make the
required setting.
– »OFF« to »5MS«: off to 5 milliseconds.
4
Switch back to the left column with » « and make the setting for »REAR
DELAY«.
– »OFF« to »15MS«: off to 15 milliseconds.
Testing the volume level of the individual channels
with a test signal
A test signal can be created for each connected speaker to check the volume
level. »OFF« is the default value.
1
Select »SPEAKER SETUP« with » « or » « and confirm with
»DEMO/OK«.
2 Select »TEST TONE« with » « or » «.
3 Use » « to move to the right column.
– »ON« and »OFF«.
4
Use » « or » « to select »ON« and confirm with »DEMO/OK«.
– The test signal can be heard briefly from loudspeaker to loudspeaker
(sequence: front left, centre, front right, surround right, surround left,
subwoofer).
5 To end the test signal select » « or » « »OFF« and confirm with
»DEMO/OK«.
23