Table of Contents
Advertisement
9 9
Electrical Information
A. Wiring the Appliance
Note: Electrical wiring must be installed by a licensed
electrician.
Note: This appliance must be electrically wired and grounded
in accordance with local codes or, in the absence of local
codes, with National Electric Code ANSI/NFPA 70-latest
edition or the Canadian Electric Code, CSA C221.1.
CAUTION
• Prevent accidental appliance operation when not attended.
• Unplug or remove batteries from remote control if absent or
if appliance will not be used for an extended period of time.
• Property damage possible from elevated temperatures.
STANDING
PILOT
WHT
RED
Figure 9.1 Standing Pilot Ignition Wiring Diagram
16
VALVE
Heat & Glo • FB-IN, FB-GRAND • 783-908 Rev. J • 2/07
Appliance Requirements
• This appliance DOES NOT require 110-120 VAC to
operate.
• It is recommended that a 110 VAC junction box be
connected for use with fan or remote control. (See Figure
9.2 for junction box wiring).
WARNING
Wire 110V to electrical junction box.
Do NOT wire 110V to valve.
Do NOT wire 110V to wall switch.
• Incorrect wiring will damage millivolt valves.
• Incorrect wiring will override IPI safety lockout
and may cause explosion.
ON/OFF Switch
• An ON/OFF switch is included with appliance and should
attached to surround/facing. (See Installation instructions
for remote control).
• If desired an additional wall switch or thermostat may
be added to system as shown in Figure 9.1).
ON
OFF
ON/OFF
SWITCH
REMOTE SWITCH
PIGTAIL
OPTIONAL WALL SWITCH,
THERMOSTAT OR REMOTE
Hide quick links:
Advertisement
Table of Contents
