Assembly - Honda HS720A Owner's Manual

Assembly

1. Loosen the two 8 mm flange nuts.
2. Raise the handlebar into position and then tighten the two 8 mm
flange nuts securely.
(A type shown)
3. AM type only: Install the discharge chute using the three 6 mm
flange bolts and 6 mm self-locking nuts. Make sure the bolt head
goes on the inside and the nuts on the outside. Tighten the nuts
to the specified torque:
TORQUE: 7 ft-lbs (10 N•m).
(AM type only)
6 mm FLANGE
BOLT (3)
(inside chute)
4
4. Lift the spark plug door
and attach the spark plug
cap to the spark plug.
5. Remove any packing
material from the
handlebar and side of the
snow thrower.
Add Engine Oil
1. The snow thrower is
8 mm FLANGE shipped WITHOUT OIL in
the engine.
NUT (2)
2. With the snow thrower on
a level surface, remove the
oil filler cap/dipstick.
3. Add oil from the included
bottle of oil into the oil filler
opening to the top of the
filler opening (upper limit).
All Honda engines are run
at the factory prior to
packaging. Most of the oil
is removed prior to
shipment; however, some
oil remains in the engine.
The amount of oil left in the
engine varies.
4. If you don't use the
supplied oil, add enough
6 mm NUT (3)
recommended oil
(outside chute)
(page
level to the top of the oil
filler opening.
5. Do not overfill the engine with oil. After filling the engine with oil,
screw the filler/cap dipstick in and remove the hang tag near the
recoil starter grip that says "The engine has no oil".
Please Register Your Snow Thrower
Please take a few minutes and register your purchase with Honda.
You can register by completing and mailing the registration card on
the back cover of this book or going on-line to
www.powerequipment.honda.com
Registration.
Before Using Your Snow Thrower
Before using the snow thrower, all operators must read the following
sections:
• FOR YOUR SAFETY
• BEFORE EACH OPERATION
• OPERATION
• MAINTENANCE SCHEDULE
UPPER LIMIT
12) to bring the oil
and clicking on Product
(page 2)
(page
(page 6)
(page
5)
11)