Humminbird 585C Operation Manual page 23

FF585c_Man_English_531363-1_B.qxd
www.reelschematic.com
www.reelschematic.com
Troubleshooting
Before contacting the Humminbird® Customer Resource Center, please read the
following section. Taking the time to review these troubleshooting guidelines may
allow you to solve a performance problem yourself, and therefore avoid sending your
unit back for repair.
FishFinder Doesn't Power Up
If your FishFinder doesn't power up, use the Installation Guide that also comes with it
for specific confirmation details, making sure that:
• the power cable is properly connected to the FishFinder control head,
• the power cable is wired correctly, with red to positive battery terminal and
black to negative terminal or ground
• the fuse is operational
• the battery voltage of the power connector is at least 10 Volts.
Correct any known problems, including removing corrosion from the battery terminals
or wiring, or actually replacing the battery if necessary.
FishFinder Defaults to Simulator with a Transducer Attached
A connected and functioning transducer will cause the newly-started FishFinder to go
into Normal operating mode automatically. If, when you power up the FishFinder, it
goes into Simulator mode automatically, even though a transducer is already
connected, this means that the control head is not detecting the transducer. Perform
the following troubleshooting tasks:
• Using the Installation Guide that also comes with your FishFinder, check to
make sure that the transducer cable is securely connected to the FishFinder.
Reconnect if necessary, and power up the FishFinder again to see if this fixes
the problem.
• Replace the transducer with a known good transducer if available and power
up the control head again.
• Check the transducer cable and connector. Replace the transducer if the cable is
damaged or corroded.
38
12/27/2004 8:33 PM Page 44
Display Problems
There are several main conditions or sources of possible interference that may cause
problems with the quality of the information displayed on the control head. Look in the
following table for some symptoms of display problems and possible solutions:
Problem Possible Cause
The control head loses power at If the power output of your boat's engine is
high speeds. unregulated, the control head may be protecting
itself using its over-voltage protection feature. Make
sure the input voltage does not exceed 20 Volts.
When the boat moves at higher The transducer position may need to be adjusted. A
speeds, the bottom disappears mix of air and water flowing around the transducer
or suddenly weakens, or the (cavitation) may be interfering with the inter-
display contains gaps. pretation of sonar data. See your Installation Guide
for suggestions on adjusting the transducer position.
Electrical noise from the boat's engine may be
interfering with sonar reception. See Finding the
Cause of Noise for more information.
There are no fish detected, Sonar readings may be affected if the transducer is
even when you know they are not positioned correctly (i.e. mounted at an angle, not
in the water under the boat, straight down), or there is some kind of mechanical
or sonar readings seem weak interference, either because it is mounted inside a
or faulty. hull that is too thick for proper sonar transmission,
the bond between the transducer and the hull is not
airtight, or because the transducer is dirty. Check with
your Installation Guide for guidance on re-positioning
the transducer, and make sure the transducer is clean.
Low battery voltage may be affecting the power of
signal transmission.
Electrical noise from the boat's engine may be
interfering with sonar reception. See Finding the
Cause of Noise for more information.
39