IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 0844 844 4558 UK...
Page 3
13 amp socket. • YOUR PRODUCT IS SUPPLIED WITH AN 1. No earth required. Flymo products are double insulated to MAINS CABLE FITTED WITH A FEMALE CONNECTOR EN60335 and under no circumstances should an earth 1. If the supply cord is damaged, it must be replaced be connected to any part of the product.
Assembly Instructions Preparing your lawnmower for use • Make sure that the cable does not become trapped • Your lawnmower is supplied with the upper handle folded between the handles over the machine for packing and transportation. Grassbox handle Handle in Operating Position Attach the grassbox handle as illustrated in figure B 1.
Mowing 1. For the best results mow the outside edge of the lawn in a clockwise direction first. (K1) 2. Then start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut.
Adjusting the Cutting Height Cutting Height Adjustment • NOTE • Height of cut is adjusted by raising or lowering the A medium height of cut is recommended for most lawns. blade using the height adjustment lever (Q & R) The quality of your lawn will suffer and collection •...
Caring for your Lawnmower Cleaning IMPORTANT: It is very important that you keep your lawn- mower clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. USE GLOVES. Switch off and remove the plug from the mains before cleaning. It is recommended that you clean your lawnmower straight after mowing while the grass is still wet.
A network of specialist dealers can be found in your local 3. Prepacked spares are available from most Husqvarna Yellow Pages. To obtain service on your Flymo product sim- UK Ltd. stockists. ply telephone or visit your local Service Centre.
Need help?
Do you have a question about the UltraGlide and is the answer not in the manual?
Questions and answers