Southwind Information; Lamps And Bulbs; Motor Home Fuses And Circuit Breakers - Fleetwood 2008 Southwind User Manual

SOUTHWIND INFORMATION
LAMPS AND BULBS
Replace bulbs with the listed bulb or equivalent.
Interior - l2-volt
Bedroomfliving room
reading lights ..............................
.1
139IF, 12-volt
Bedroom soffit lights .................. GE 5312, 12-volt
Dinette decor light ........................ GE 921, l2-volt
Fluorescent Light .................... F15T8-CW, l2-volt
Round Halogen lights ........................ lOW, l2-volt
Vanity light ..................................... 9019-F, 12-volt
Exterior
Back-up lights ............................. GE 1156, l2-volt
Entry step light ............................. GE 193, l2-volt
Front clearance lights ................. GE 67DP, 12-volt
Front tum signal
lights ........................... Peterson 426A-ll, 12-volt
Headlight, halogen
high/low beam ............... Hella HI U-HlL, 12-volt
License plate light ...................... GE 5312, l2-volt
Mirror tum signal lights ............. GE 1895, 12-volt
Porch lights ............................ Jensen 1003, l2-volt
Rear clearance lights .................... GE 193, 12-volt
Running light.. ..................... Hella #78274, 12-volt
Side marker lights ......................... GE 194, l2-volt
Stop/turn/taillights ...................... GE 1157, l2-volt
CAUTION
Before relamping, disconnect power source by remov-
ing fuse or placing circuit breaker and control switch in
OFF position.
Halogen bulbs operate at extremely high temperatures
and pressures and will shatter if not handled correctly.
Always use a soft dry cloth or cotton gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with rub-
bing alcohol.
Do not use near flammable or combustible materials
andlor objects which may be sensitive to fading or drying.
Use bulbs designed or specific by manufacturer as to
style, wattage and voltage.
tfl
NOTE
I
Consult Chassis Operator's/Owner's Guide/Manual
for automotive lamp replacement on chassis cab. This
would include headlamps, tum signals and running
lamps.
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt circuit breakers and 12-volt fuses
are located on three separate panels. The pur-
pose of these three panels is to provide electrical
circuit breakers and fuses to intell'Upt current
flow if a circuit is overloaded.
1.
l20-volt House Electrical-
This electri-
cal panel is located under the bed. This
panel is very similar to a residential panel
with resettable breakers.
2. Fleetwood Automotive l2-volt System -
This panel is located in a driver's side com-
partment. This electrical center contains
battelY disconnect systems, entry step, fog
light, and some other automotive circuitry.
3. I2-volt Chassis Fuses -
This electrical
panel is located under the driver's side dash
area.
. . I
WARNING
1
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or label. Doing so constitutes a fire hazard.
04-1