End-Of-Cycle Signal Control; Push To Start Dryer Button; Soft-Heat System; Cool Down - Kenmore Washer/Dryer Owner's Manual And Installation Instructions

END-OF-CYCLE SIGNAL CONTROL
Irl.Jlr._!_m "-I[=.] i [ _ i'i "=
Your dryer sounds a signal when
a drying cycle is finished.
The signal is helpfulwhen you are drying
permanent press, synthetics,and other
items. These items should be removed
from the dryer as soonas it stopsin
order to preventwrinkles.
END OF CYCLE SIGNAL
SIGNAL SIGNAL
OFF • • ON
PUSH TO START DRYER BUTTON
Use this control to start the dryer.
Be sure the dryer door is .closed.
Opening the door stops the dryer. It
will not start again until you close the
door and press the PUSH TO START
DRYER Button. Be sure the Cycle
Selector Control (Timer) is still on a
dry setting.
PUSH TO
START DRYER
END OF CYCLE SIGNAL
SIGNAL SIGNAL
OFF • • ON
SOFT-H EA'P'SYSTEM
_Ift,_mr(,Jq_im :1:al[_ i'ilm
SOFT-HEAP System guards against
overdrying.This helps your fabrics
retain the natural moisture they nee¢i
prevents static, and reduces pilling -
the formation of small lint-like balls
on the surface of garments. Pilling
is the natural result of washing and
wearing of garments.
Kenmore dryers help prevent overdryim
so you get outstanding fabric care. In th
automatic drying and timed drying cycle_
clothes are dried at the temperature yOL
selected until the last few minutes of th_
cycle. The dryer then switches to low hea
COOL DOWN
Approximately ten minutes before the
end of the automatic drying and timed
drying cycles, clothes are tumbled with-
out heat to help reduce wrinkles and mak
clothes more comfortable to handle.
48