Advertisement
English
The following symbols are used on unit:
P Pulse operation
0 Power off
1 Low speed
2 High speed
Assembly
Warning! Make sure that the appliance is
switched off and unplugged.
Blender
Assemble the jar (3) by first placing the seal
(5) on the blade assembly (4).
Position the blade assembly in the
underside of the jar (3). Rotate the
assembly in an anti-clockwise direction
until tight.
Warning! Do not over-tighten.
Place the assembled jar on the motor
housing (6) and rotate it in a clockwise
direction until it locks in position.
To unlock rotate it in anti-clockwise
direction.
Note: Take care when emptying the jar and
when handling the blades, as they are
sharp.
Mills
Put the ingredients into the mill (9 or 10). Fit
the lid (11 or 12) over the mill and rotate it in
an anti-clockwise direction until it locks in
place.
Place the assembled mill on the motor
housing (6) and rotate it in a clockwise
direction until it locks in position.
To unlock rotate it in anti-clockwise
direction.
Use
Switching on and off
Rotate the control dial (7) to select the
required speed.
Pulse (P) can also be used to give greater
control.
Once blending is completed, the Blender
can be turned off, by returning the switch to
the off (0) position.
Blending
Place the appliance on a clean, flat work
surface.
Add the ingredients to the jar then fit the lid
(2) and filler cap (1).
Note: Do not exceed the maximum capacity
of 1.4 litres.
Connect the appliance to a suitable
electrical supply. Rotate the control dial (7)
to the required speed.
When blending is complete return the
switch to the off (0) position.
Once the blades have come to a complete
stop, rotate the jar (3) in an anti-clockwise
direction and lift it from the motor housing
(7). Remove the lid (2). Pour the ingredients
into a suitable container.
Note: Ingredients can be added by inserting
them through the hole left when the filler
cap (1) is removed.
Warning! Never operate the Blender without
the lid (2) fitted.
Note: Do not operate the blender for longer
than 2 minutes. After each 2 minute session
the blender must be allowed to cool down
for at least 10 minutes.
Note: The motor is equipped with an auto
resetting thermostat. This may operate and
stop blending if the appliance is
over-loaded. If this should happen,
disconnect the unit from the electrical
supply, remove some of the contents of the
jar and allow the blender to cool down. The
thermostat will take a few minutes to reset.
-5-
Advertisement
