Advertisement
Connecting the receiver and operating the system
1. Screw the antennas in to the antenna sockets on the front of the receiver.
Point them both antennas upwards in a vertical position.
2. Ensure your mixer/amplifier is turned down before connecting the receiver.
3. Connect the receiver using the Mix output using the supplied 6.35mm jack (unbalanced) lead. This should go to the
"Mic In" on your mixer or amplifier. Control of individual microphone channel levels is via the individual Channel volume
controls on the front of the receiver.
Alternatively if you are using a multi-channel mixer you can connect the receiver using the individual Channel outputs
using XLR (balanced) leads (not supplied).
4. Plug the DC power adaptor into the DC socket on the rear of the receiver. Plug the other end in to a suitable AC outlet.
5. Press the Power switch on the front panel of the receiver to "I". All four Channel power indicator LEDs should light RED.
6. Ensure all the Channel volume controls are turned down to minimum. Turn your chosen Microphone on using the
Power Switch. The LED status indicator will turn green to indicate it is on, or yellow if Mute is selected. If the battery level
is low the LED will turn red to indicate it requires recharging.
7. When a microphone is turned on the status LED on the corresponding Channel on the receiver will also light up. The
radio frequency (RF) indicator will turn yellow to show a signal is being received from the microphone.
The audio frequency (AF) indicator will turn green to show audio is being received (i.e. it will pulse with your voice as you
speak in to the microphone).
8. Turn the microphone power switch to mute or "off" when you have finished speaking/singing in to the microphone and
before you place it down on a table.
The receiver has 4 separate volume controls, one for each microphone. Use this in conjunction with the controls
on your mixer/amplifier to adjust the sound level required. If the sound is distorted check the volume level controls
on the receiver and the mixer/amplifier. If sound continues to be distorted move the microphone further away from
your mouth and also check the battery is fully charged.
The receiver can be mounted in to a standard 19" rack mount case/rack using the supplied rack-mount brackets.
Fix one of these to each side of the receiver using the supplied screws, and then fit the unit in to your rack.
The microphones have a maximum effective range of around 100m, depending on the environment in which the
system is being used. This can be reduced to 60m in many situations. If the sound becomes intermittent move the
microphones closer to the receiver. Interference is occasionally possible when the distance between a microphone
and the receiver is less than 1.5m. To achieve the best possible system performance, please keep the
microphones at least 1.5m away from the receiver.
Ideally suited for:
1.
Aerobics instructors
2.
Vocalists & singers
3.
Public speakers
4.
Fitness instructors
5.
Dance instructors
6.
Musicals & theatre
7.
Schools & colleges
8.
DJs & musicians
9.
Auctioneers
10. Video & filmmaker
Kam KWM Quartet features
1. Uses the UHF 863.00 - 865.00MHz band
2. 4 x colour-coded handheld microphones
3. 2 x removable/adjustable antennas
4. Microphones are USB rechargeable using supplied cable (maximum 2 at a time)
5. Individual (balanced) and mixed (unbalanced) audio outputs
6. Receiver uses external DC power supply
7. Ideal working distance is up to 100 meters
8. Easy to use - the receiver connects directly to an audio mixer or amp
Advertisement
