Cambridge Audio azur 851D Quick Start Manual page 7

Upsampling dac/digital pre-amp
Hide thumbs Also See for azur 851D:
Table of Contents

Advertisement

triangle is intended to alert the user to the presence of un-insulated
'dangerous voltage' within the product's enclosure that may be of
The exclamation point within an equilateral triangle is intended to alert
the user to the presence of important operating and maintenance
instructions in the service literature relevant to this appliance.
The crossed-out wheeled bin is the European Union symbol
for indicating separate collection for electrical and electronic
equipment. This product contains electrical and electronic
equipment which should be reused, recycled or recovered
and should not be disposed of with unsorted regular waste.
Please return the unit or contact the authorised dealer from whom you
purchased this product for more information.
This product complies with European Low Voltage (2006/95/
Environmentally-friendly design of Energy-related Products (2009/125/
manual. For continued compliance only Cambridge Audio accessories
should be used with this product and servicing must be referred to
This
product
meets
the
Authority's Radio communications and EMC requirements.
Gost-R Mark
This product meets Russian electronic safety approvals.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Re-orient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Australian
Communications
azur
IMPORTANT – The unit will become hot when in use. Do not stack
multiple units on top of each other. Do not place in an enclosed area
Ensure that small objects do not fall through any ventilation grille. If this
happens, switch off immediately, disconnect from the mains supply and
contact your dealer for advice.
Choose the installation location carefully. Avoid placing it in direct
as lighted candles, should be placed on the unit. Also avoid locations
subject to vibration and excessive dust, cold or moisture. The unit can
be used in a moderate climate.
This unit must be installed on a sturdy, level surface. Do not place in a
sealed area such as a bookcase or in a cabinet. Do not place the unit on
an unstable surface or shelf. The unit may fall, causing serious injury to
a child or adult as well as serious damage to the product. Do not place
other equipment on top of the unit.
nearby due to possible interference.
Electronic audio components have a running in period of around a week
settle down and the sonic properties will improve over this time.
The unit should be operated only from the type of power source indicated
on the marking label. If you are not sure of the type of power-supply to
your home, consult your product dealer or local power company.
<0.5W in this state. To turn the unit off, switch off at the rear panel. If
you do not intend to use this unit for a long period of time, unplug it from
the mains socket.
Do not overload wall outlets or extension cords as this can result in a risk
power cords, damaged or cracked wire insulation and broken plugs are
Be sure to insert each power cord securely. To prevent hum and noise,
do not bundle the interconnect leads with the power cord or speaker
leads.
To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any
an aerosol at or near the unit.
Batteries may contain substances harmful to the environment. Please
dispose of any discharged batteries with due consideration and in
accordance with local environmental/electronic recycling guidelines.
Before making any connections to loudspeakers, make sure all power is
turned off and only use suitable interconnects.
These units are not user serviceable. Never attempt to repair,
disassemble or reconstruct the unit if there seems to be a problem.
A serious electric shock could result if this precautionary measure is
ignored. In the event of a problem or failure, please contact your dealer.
851D
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Azur 8510

Table of Contents