Nokia Power Pack DC-1 User Manual page 4

seconds. If the amber indicator
light is shown, the power pack is
Charge a device battery
You can use the power pack to
charge a battery in two
compatible Nokia devices at the
same time.
To charge a device battery when
no charger is connected to the
power pack, do the following:
1. Connect your Nokia device to
either charger plug.
• To connect the device to the
charger plug provided with
a rewindable cable, lift the
edge of the rubber cover,
uncoil the cable, and insert
the plug into the charger
connector on your device.
• To connect the device to the
"DC OUT" plug, insert one
4
discharged and must be charged
again for use.
2. Press and hold the power key
© 2007-2008 Nokia. All rights reserved.
end of the supplied
connectivity cable to the
plug and the other end to
the charger connector on
your device.
for about 2 seconds to switch
on the power pack. The green
indicator lights are shown if
the power pack has charge.
The green indicator lights roll
while charging. (When you
charge a low-power device
such as a Bluetooth headset,
the green lights may be
continuously shown at the final
stage of charging.) The less
lights are shown, the less