Nokia Power Pack DC-1 User Manual page 3

When you disconnect the power cord
of any enhancement, grasp and pull
the plug, not the cord.
Charge power pack
Before you can use the power pack
to charge a battery in a
compatible Nokia device, you must
charge the internal battery of the
power pack.
The power pack has an internal,
nonremovable, rechargeable
battery. Do not attempt to remove
the battery from the device, as you
may damage the device.
1. Plug the charger cable into the
charger connector indicated
with "DC IN".
2. Connect the charger to a power
source. The green indicator
lights roll while charging. The
more lights are shown, the
more charge is left in the power
pack. Charging the power pack
3. When the battery is fully
While the power pack is connected
to a charger, you can use the
power pack to charge one or two
Nokia devices.
If the power pack cannot be
charged (for example, because the
operating temperature is too low
or high), the red indicator light is
shown.
To check how much charge is left
in the power pack when it is not
connected to a device, press and
hold the power key for about 2
© 2007-2008 Nokia. All rights reserved.
fully may take up to 10 hours if
the power pack is not
connected to a Nokia device.
charged, all four green
indicator lights are shown.
Disconnect the charger from
the power source, and unplug
the charger cable from the
power pack.
3