Maintenance Schedule - Superior Signature DRT63STTEN Care And Operating Instructions

INNOVATIVE HEARTH PRODUCTS • SEE-THROUGH DIRECT-VENT GAS FIREPLACES (DRT63STTEN / DRT63STTEP) • CARE AND OPERATION INSTRUCTIONS

MAINTENANCE SCHEDULE

WARNING: BURN HAZARD.
Turn OFF gas and electrical power to the fireplace, and
allow it to cool before cleaning or servicing the appliance.
Annually (before onset of burning season)
MAINTENANCE TASK
Inspect/Clean Burner, Logs,
and Controls
Check Flame Patterns and Flame Height
Inspect/Clean Pilot and Burner
Check Vent System
Appliance Checkout
Replace Glowing Embers
Periodically (after burning season)
MAINTENANCE TASK
Clean Firebox Interior
Check Flame Patterns and Flame Height
Clean Front Glass Enclosure Panel
ACCOMPLISHING PERSON
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Homeowner/Qualified Service
Technician
ACCOMPLISHING PERSON
Homeowner
Homeowner
Homeowner
PROCEDURE
Inspect valve and ensure it is properly operating. Check piping for
leaks. Vacuum the control compartment, fireplace logs and burner area.
Refer to Figures 20 and 21 on Page 16 and verify the flame pattern and
height displayed by the appliance conform to the illustration. Flames must
not impinge on the logs. Ensure flames are steady (not lifting or floating).
Refer to Figure 22 on Page 17. Remove any surface build-up on pilot
and burner assembly. Wipe the pilot nozzles, igniter/flame rod and hood.
Ensure the pilot flame engulfs the flame sensor as shown.
Inspect the vent system at the top and at the base (within the firebox) for
signs of blockage or obstruction. Look for any signs of dislocation or
deterioration of the vent components (reconnect or replace as necessary).
Perform the appropriate appliance checkout procedure detailed in this
manual.
Remove old ember materials and vacuum the ember placement area.
Place new embers per instructions on Page 13.
PROCEDURE
Carefully remove logs, rockwool and volcanic stone. Vacuum out interior
of the firebox. Clean firebox walls and log grate. Replace logs, rockwool
and volcanic stone as detailed in this manual.
Refer to Figures 20 and 21 on Page 16 and verify the flame pattern
and height displayed by the appliance conforms to the picture. Flames
must not impinge on the logs.
Clean as necessary following the directions provided in this manual.
DO NOT TOUCH OR ATTEMPT TO CLEAN GLASS WHILE HOT.
23