Cr Oss Fad Er - Gemini CDMP-7000 User Manual

m i x e r c o n t r o l s
c r o s s f a d e r c o n t r o l s

cR oSS FAd eR

The CROSS FADER (41) allows mixing and cutting from
CHANNEL 2 to CHANNEL 3. The CROSS FADER (41) in
the CDMP-7000 is removable and if the need arises can
be replaced easily.
cR oSS FAd eR con T R oL S
The CROSS FADER (41) has three sets of controls as-
sociated with it: CROSS FADER START (39), CROSS
FADER REVERSE (40) CROSS FADER CURVE ADJUST
(42).
The CROSS FADER START (39) when enabled will allow-
playback simply by moving the CROSS FADER (41) from
side to side. Moving the cross fader in the direction of
the cued deck will begin playback of that deck. When
the cross fader is moved all the way to the opposite side
of the currently playing disc, the unit will pause playback
of that deck.
The CROSS FADER REVERSE (40) when enabled inverts
the cross fader so that the left side of the cross fader
becomes channel 3 and the right of the cross fader be-
comes channel 2.
The CROSS FADER CURVE ADJUST (42) allows for two
different cross fader slopes for entering/cutting tracks:
gradual and steep.
m i c r o p h o n e c o n t r o l s
mic conTRoLS
The CDMP-7000 has two mic inputs (front and rear
panel) that are controlled via the MIC VOLUME CON-
TROL (46).
The 2-BAND MIC EQ (47) allows for tonal adjustments
of the mic signal across the LOW and HIGH bands.
The 3-position MIC TALKOVER SWITCH (48) turns the
mic signal ON or OFF as well as enabling the talkover
setting, which attenuates the PGM mix so the mic signal
can be clearly heard.
21
- .
c d m p 7 0 0 0 m a n u a l • g e m i n i d j c o m