Control Register Reference - Dalstar DS3-11-01M0 User's Manual And Referenceeference

1M30P Camera User's Manual
3.3 Clock Commands
Table 11: Summary of Clock Commands
Control
Read Camera
Type
Read
Firmware
Revisions
Reset Camera
Control
Register
Binning
Register
Integration
Time
Frame Rate

3.4 Control Register Reference

A number of functions and modes depend on the Control Register settings. These settings
are detailed in the following sections.
The "Write Control Register" command is used to write a register that controls specific
camera triggering and test functions. This command must be followed by a data byte
with bits defined as shown in the following table.
The "Read Control Register" command allows interrogation of the camera to determine
current configuration of the Control Register.
DALSA
Write Command
Hex Binary
NA NA
NA NA
80h 1000 0000
82 1000 0010
85 1000 0101
8A 1000 1010
8B 1000 1011
8C 1000 1100
8D 1000 1101
8E 1000 1110
8F 1000 1111
Read Command Function
Hex Binary
C3 1100 0011 Reads camera type
register (1M30=41h)
C5 1100 0101 Reads camera firmware
revision
NA NA Resets all registers to
default values
C2 1100 0010 Control Register
commands
NA NA Controls horizontal and
vertical binning
NA NA LS Byte of an 18 bit
Integration Time
NA NA Center Byte of an 18 bit
integration time
NA NA MS Byte of an 18 bit
integration time
NA NA LS Byte of an 18 bit
frame Rate Time
NA NA Center Byte of an 18 bit
frame Rate Time
NA NA MS Byte of an 18 bit
Frame Rate Time
21
03-32-10001-02