Lock Code - Panasonic G600 Service Manual

7.6

Lock Code

NOTE:
See section 7.2.1 for a list of the equipment and setup procedures required to perform the f
calibration procedures.
To perform the following procedures the UUT must be placed into Test Mode.
7.6.1 Check current lock code
1. (Figure 29) At the Channel box press F4 and highlight VIEW LOCK CONDITION. Press ENTER.
Figure 29: View lock code
2. The display will show the current lock status and lock code for the UUT.
7.6.2 Change current lock code
1. At the Channel box
2. (Figure 30) Press ENTER to unlock the UUT. The current lock code will be used.
Figure 30: Program lock code
3. Enter "0000" to reset the UUT to factory defaults. The UUT will be locked using the lock
MCUK980101C8
Service Manual
press SHIFT and F4 and highlight PROG LOCK CONDITION. Press ENTER.
Section 7
7 - 21
TEST AND MEASUREMENT
g adjustment and
600-0740
600-0741
".
Issue 1
Revision 0