Kenmore POWER-MATE 116.24614 Owner's Manual page 17

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um, the aaitator must be cleaned every time
the belt is changed,
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
Clean Aaitator
every week
every month
LIGHT -
(used 1 time/week)
every 2 months
IMPORTANT
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the Power-Mate ® agitator
and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
Agitator Assembly
Belt Pulley7
Bcush UnH
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
brush
sprocket.
NOTE: See
PARTS AND
FEATURES
or
e
t
Agitator End Cap
for belt number.
2. Place agitator
assembly back
into Power-
Mate ® .
Cover Base
3. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.
4. Rotate cover
back. Press _.,..'_
cover firmly until __:_.__
side and rear _/_L_'V_J_._.-,',T_
tabs snap into __'/:.-..'_.._._
place "__'_
Make sure there
Side Rear
Latch Latches
is no gap
between the cover and base.
5. Turn Power-Mate®upside down and
replace two (2) cover screws.
17