Related Manuals for Factor V-RVC-PRO
Summary of Contents for Factor V-RVC-PRO
-
Page 1: Owners Manual
PREMIUMAUDIOVIDEOANDPOWERPRODUCTS V-RVC-PRO Owners Manual info@factorelectronics.com www.factorelectronics.com... -
Page 2: Important Safety Instructions
IMPORTANT NOTE: THIS OWNER'S MANUAL IS PROVIDED AS AN INSTALLATION AND OPERATING AID. FACTOR ELECTRONICS DOES NOT ASSUME ANY RESPONSIBILITY AS TO ITS ACCURACY AND SHALL NOT BE LIABLE IN TORT OR CONTRACT FOR ANY DIRECT, CONSEQUENTIAL OR INCIDENTAL LOSS OR DAMAGE ARISING FROM THE INSTALLATION, USE OR INABILITY TO USE THIS PRODUCT. - Page 3 Electronics V- Series commercial amplifiers. The V-RVC-PRO allows Factor Electronics amplifiers to be expanded to suit the customers needs. The V-RVC is very easy to install and operate. Please read this entire manual to get the most from your V-RVC-PRO.
- Page 4 The V-RVC-PRO includes two RJ45 crimp-on connectors. Use a good quality RJ45 crimping tool to complete the connections. Diagram B TIA/EIA 568A Wiring Up to three V-RVC-PRO units can be daisy chained on one Cat5/6 wire and connected to one Factor Electronics amplifier. Diagram C info@factorelectronics.com...
- Page 5 V-RVC-PRO in-wall mic/line pre-amplifiers. Connect the RJ45 output of the X-Music to the RJ45 input of the V-RVC-PRO. Then connect the RJ45 output of the V-RVC-PRO to the RJ45 input of the second V-RVC-PRO. Now connect the RJ45 output of the last V-RVC-PRO to the V-RVC input of the Factor Electronics amplifier.
- Page 6 V-RVC-PRO units. Cable runs from the V-RVC-PRO to the amplifier can be made two ways. 1. Cat5/6 cable run from the V-RVC-PRO back to the amplifier and terminate at the V-RVC-RJ45. We recommend Cat5/6 cable runs of 100' max and shielded Cat5/6 runs of 200-300' max.
- Page 7 RJ45 RJ45 3.RJ45 IN Connect this to the OUT of another V-RVC-PRO in a daisy chain or from the output of an X-Music in-wall iPod dock. 5.RJ45 Out1 Connect this to another V-RVC-PRO input in a daisy chain or to the V-RVC input of the amplifier.
- Page 8 Back Panel Controls and Connections ? RVC Set this dip switch to ON when using a single V-RVC with a Factor Electronics amplifier. This switch enables the remote master volume control feature of the V-RVC. When using multiple V-RVC's on a single amplifier you must designate one V-RVC to be the master volume controller by setting the switch to ON.
- Page 9 Connect the priority contact to the remote mute contacts on any Factor Electronics amplifier. Once the connections are made pressing the priority switch IN will allow the V-RVC-PRO to be the only source broadcast in the amplifier. Example: This is common in golf courses, restaurants, and hotels where there may be background music played in the building.