Easy Radiant Works PPRTH-50-15 Installation & Operating Instructions Manual page 15

4. Slide reflector at primary (burner end) into place.
5. Attach burner hanger bracket (see PTH-B) to heater burner with nuts & bolts
provided.
6. Attach heater head to Primary tube with 4 bolts and nuts supplied.
7. Slide reflector under 1" lip on heater cover.
8. Slide 6" reflector splice (see diagram PTH-1060) over end of reflector.
9. Slide the next reflector into place from the exhaust end of unit and slide reflector into
6" reflector splice.
10. Install the reflector end cap (see PTH-1050) and exhaust vent, joining together and
securing joints.
11. Connect the burner to the gas supply using a suitably approved flexible gas
connector. (see
(Not recommended for outdoor use if there is movement of heater due to wind)
1. Suspend hanging supports with #10 chain, (40 lbs working load limit)
adhering strictly to the hanger locations. The first wire hanger must be no more than
6 inches from the flange.
Attach wire hanger and install the 4" dia. primary tube along with other tubes into the
2.
hangers joining the lengths of tube together and securing joints.
IMPROPER HANGER PLACEMENT CAN CAUSE THE RADIANT TUBE TO WARP AND
VOID WARRANTY.
THE BAFFLE MUST BE INSTALLED AT THE EXTREME OPPOSITE END OF THE HEATER
FROM THE BURNER.
4. Slide reflector at primary (burner end) into place.
5. Attach control box hanger bracket (see PTH-1030) with nuts and bolts provided.
Burner employs control box hanger to connect a hanging chain to stabilize the unit
6. Attach heater head to Primary tube with 4 bolts and nuts supplied.
7. Slide reflector under 1" lip on heater cover.
8. Slide 6 ft reflector splice (see diagram PTH-1060) over end of reflector.
9. Slide the next reflector into place from the exhaust end of unit and slide reflector into
6" reflector splice.
10. Install the reflector end cap (see PTH-1050) and exhaust vent, joining together and
securing joints.
To prevent "walking" of the reflectors, the first and second reflector can be joined
together at the splice with a sheet metal screw. Do not attach more than two
reflectors together.
11. Connect the burner to the gas supply using a suitably approved flexible gas
connector. (See GAS SUPPLY, HEATER EXPANSION, AND FLEXIBLE GAS
CONNECTION
GAS SUPPLY, HEATER EXPANDSION, AND FLEXIBLE GAS CONNECTION)
CHAIN-MOUNT INSTALLATION