Taillamps - GMC 2003 Sonoma Owner's Manual

4. Install a new bulb.
5. Reinstall the lens and tighten the screws.
If equipment such as a cap or camper is installed on
your vehicle, a center high-mounted stoplamp feed wire
is provided along the driver's side rear frame. This
wire should be used to install a center high-mounted
stoplamp in the cap or camper.
3. Remove the bulb.

Taillamps

1. Open the tailgate.
3. Pull the assembly away from the pickup side panel.
4. Turn the socket counterclockwise to remove it.
Push the tab in while you turn the socket.
5. Pull the bulb out.
6. Push the new bulb into the socket.
7. Put the socket into the assembly and turn the
socket clockwise until it locks in place.
8. Reinstall the assembly. Install and tighten the
screws.
9. Close the tailgate.
2. Remove the screws
from the lamp
assembly near the
tailgate latch.
5-59