NY 10036. long hair, gloves, ties or jewelry. CAUTION Cleco drills are designed to operate on 90 psig (6.2 bar) maximum air pressure. If the tool is properly sized and Personal hearing protection is applied, higher air pressure is unnecessary. Excessive air recommended when operating or working near this tool.
Page 3
Safety Recommendations a problem can be addressed before it becomes a debilitat- CAUTION ing injury. Any user suffering prolonged symptoms of tingling, numbness, blanching of fingers, clumsiness or • Drill bits are sharp. Handle them carefully to avoid injury. weakened grip, nocturnal pain in the hand, or any other •...
Page 4
Safety Recommendations Work gloves with vibration reducing liners and wrist sup- Warning Labels ports are available from some manufacturers of industrial The warning labels found on these tools are an essential work gloves. Tool wraps and grips are also available from part of this product.
OPERATING INSTRUCTIONS FOR YOUR SAFETY AND THE SAFETY OF OTHERS READ AND UNDERSTAND THE SAFETY RECOMMENDATIONS ON PAGES 2 thru 4 BEFORE OPERATING A DRILL. OPERATION LUBRICATION The 135DPV-B series drills are designed to operate on 90 An automatic in-line filter-lubricator is recommended as it PSIG (6.2 bar) air pressure.
Page 6
SERVICE INSTRUCTIONS — DISASSEMBLY DISASSEMBLY Unscrew and remove the gear case from the handle. Re- move the rotational stop set screw, No. 864193, and un- Insert a hex wrench into the drill chuck and tighten the chuck screw the speed adjusting cap, No. 863987. Note: The securely.
Page 7
SERVICE INSTRUCTIONS — REASSEMBLY REASSEMBLY The tool is reassembled in the reverse order of disassem- bly. Wash all parts thoroughly in a solvent and inspect for damage or wear before reassembly. The rotor and spindle bearings should be replaced if excessive looseness is evident or if they feel rough.
PARTS LIST PART NO. QUANITY NAME OF PART 202279 Motor Spacer 812165 Cylinder Pin 833859 Governor Weight Pin 842768 Governor Center Bearing 843446 Rear Rotor Bearing 843871 Governor Center Stop Pin 863983 Governor Center 863984 Governor Weight 863986 Rear Bearing Plate 864196 Rotor Collar 865587...
Page 10
203617-6 203617-6 203616-8 DRILL ASSIST MODELS Bare Handle 869853 Handle Subassembly 861902 PARTS LIST — HANDLE SUBASSEMBLY PART NO. NAME OF PART QTY. PART NO. NAME OF PART QTY. 201905 863995 Trigger Assembly Indexing Blade 203616 864185 Throttle Link Pin Indexing Blade Pin 203617 864193•...
Need help?
Do you have a question about the Cleco and is the answer not in the manual?
Questions and answers