Kenmore 795.7202 Series Use And Care Manual page 14

Relnstaiilng t he Refrigerator
D oor
Left Door
1. Lower the door onto middle hinge pin (10).
2. Fit top hinge (7) over hinge lever latch (8) and into
place. Rotate lever (6) clockwise to secure hinge.
3. Install the grounding screw (5) and connect the two
wire harnesses (4).
4. Push the water tube (3) located at the top of the left
door into the hole beside the left hinge on the top of
the cabinet until it exits through the back.
5. Insert the water supply tube (3) into the connector until
you see only one scale mark. Fully insert the tube over
5/8 in. (15 mm).
6. Hook tabs on left side of hinge cover (1) under the
edge of the top hinge (7) and position the cover in
place. Insert and tighten the cover screw (1).
Right Door
1. Lower the door onto middle hinge pin (9).
2. Fit top hinge (6) over hinge lever latch (7) and into
place. Rotate lever (5) counterclockwise to secure
hinge.
3. Install the grounding screw (4) and connect wire
harnesses (3).
4. Hook tab on switch side of corner under edge of wire
opening in cabinet top. Position cover (2) into place.
Insert and tighten cover screw (1).
(3),
(8)
/
/
CAUTION
Collet
Tube
Scale Mark
Clip --
After inserting, pull the tube to
make sure that it is secure and
reinsert the clip.
14