Kenmore 795.7202 Series Use And Care Manual page 13

REMOVING AND REPLACING
REFRIGERATOR DOORS
Excessive Weight Hazard:
Use two or more people to remove and install the
refrigerator doors. Failure to do so can result in back or
other injury.
Electrical Shock Hazard
Disconnect the electrical supply to the refrigerator
before installing. Failure to do so could result in
serious injury or death.
Do not put hands, feet or other objects into the air
vents, base grille, or bottom of the refrigerator. You
may be injured or receive an electrical shock.
NOTE: Be careful when you work with the hinge and base
grille. You may be injured.
To remove the left refrigerator door:
On the back of the refrigerator, pull the water tube out of
the collet fitting on the connector by pressing the fitting
release ring (see picture below).
13
_, CAUTION: Before you begin, remove food and bins
from the doors.
(2)
(3)_
/:<
(8)
/
/
1. Open the door. Remove the top hinge cover screw (1).
Lift up the cover (2).
2. Remove the cover.
3. Pull out the tube (3).
4. Disconnect all wire harnesses (4).
5. Remove the grounding screw (5).
6. Rotate hinge lever (6) counterclockwise. Lift the top
hinge (7) free of the hinge lever latch (8).
CAUTION: When lifting the hinge free of the latch,
be careful that the door does not fall forward.
Z Lift the door from the middle hinge pin and remove the
door.
8. Place the door, inside facing up, on a non-scratching
surface.
To remove the right refrigerator door:
f
1. Open the door. Remove the top hinge cover screw (1).
Lift up cover (2).
2. Remove cover.
3. Disconnect wire harness (3).
4. Remove the grounding screw (4).
5. Rotate hinge lever (5) clockwise. Lift top hinge (6) free
of hinge lever latch (7).
6. Remove the door by lifting it off the middle hinge pin,
located at the bottom of the door.
7. Place the door on a soft, smooth surface with the
inside up to prevent damage.
CAUTION: When lifting the hinge free of the latch, be
careful that the door does not fall forward.