Finding Unlisted Product Codes; Using Picture Within A Picture; Swapping The Picture Within A Picture; How To Connect And Set Up Your Entre Entertainment Hub - Kenwood Sovereign Entre Connection And Setup Manual

How Do I Set Up My Remote?
To enter the correct product code:
1. Look up the brand name of the device you want the remote to work with.
2. Press the button for the device you wish to control (TV, DSS, or CBL
(cable)), then press and hold the CODE SETUP button on the remote.
The LED on the top of the remote will blink twice, indicating
the system is ready for you to enter a four-digit code.
3. Enter the appropriate code from the code listings, making sure the LED
blinks once after every digit is entered.
Ensure the LED blinks twice after entering the last digit of the
code. This tells you the code is valid for the device you
selected. If the code you enter is incorrect, the LED will blink
only once after the last digit.
If you enter an incorrect code, or pause 10 seconds while
pressing the numeric buttons to enter the product code, the
remote will automatically exit the code setup program. Press
the CODE SETUP button again to start over.
Finding Unlisted Product Codes
If the code list does not list the brand of your unit, you can cycle through the
available codes stored on your remote in order to locate a working code.
To cycle through the available codes:
1. Press the CODE SETUP button on the remote
2. Press the 9 button
3. Press the 9 button again
4. Press the 1 button
The remote will enter the first available code cycle for you to test. For example,
if you want to enter a specific code for your TV but discover there are no codes
listed for your TV, run through all the available codes to locate a code that is
compatible with your TV In order to select or test other codes:
1. Press the CODE SETUP button if your TV responds to the code cycle in
order to program the code into the remote.
2. Press the MODE button (the TV button, if you are looking for a code for
your TV) to advance to the next available code cycle if your TV fails to
respond to inputs from the remote. Continue until you locate a code with
the correct available functions for your TV
If your device does not respond to any of the available codes,
the Entre remote cannot be programmed to control it.
Using Picture within a Picture
While in the TV mode, press the PIP button to enable the Picture within a
Picture feature available with some TVs. Please refer to your TV's instructions
for more information about its capabilities.
Swapping the Picture within a Picture
Press the
PIP SWAP
button to swap the larger picture for the smaller one in the
upper corner of the TV screen.
Selecting an Alternate Audio Source
While in the TV mode, press
ALT AUDIO
to switch to Second Audio Program
(SAP).
Selecting an Alternate Video Source
Use the
INPUT SELECT
button to switch from Entre to broadcast TV, Cable,
Satellite, or your VCR.
TV
Broadcast TV or VCR
CABLE
Cable TV
DSS
Satellite TV
How to Connect and Set Up Your Entre Entertainment Hub
11