TacLink
The TacLink program receives GPS satellite signals to calculate the location
of your device. You can also record a NMEA log file for the use of other
applications.
NOTE: TacLink only supports NMEA format. TacLink will not start if you
have set the GPS output format to Binary Mode in
System GPS Mode for the need of third party programs.
Running TacLink
To run the program, tap
Shows the overhead
satellite positions.
Shows the signal strength
of the satellites.
A message appears if positioning is not completed in 10 minutes.
To exit the program, tap Exit at the bottom left of the screen.
6-28
More Programs
TacLink.
Settings
A red
X
indicates logging is not
activated. No
X
indicates logging is
activated.
This icon appears only if SBAS
is enabled. (See the next
section for information.)
Shows the result of GPS
positioning. A minimum of
4 GPS satellite signals is
needed to calculate your
GPS position.