Removing The Wiring Harness (Rear) And Battery Cable - Subaru 360 Sedan Service Manual

REMOVING
THE
ENGINE
HOOD
Remove the two each
5 rn
screws from both left and
right hinges of the engine
hood. At this time, remove
the cord connector of the
license plate light and
ground cord.
REMOVING THE WIRING HARNESS
(REAR)
AND
BATTERY CABLE.
Remove the 5 mn nuts and 5 mm
screw and disconnect the A,
F
and
E
wires from the genera-
tor.
A terminal : White-red wire
F terminal : White wire
E terminal : Black wire
Remove the 8
uan
nut of the
starter switch terminal and
remove the battery cable
(thick black wire) and white-
black wire (thin).
(c)
Remove the 6 mm bolt of the clip and detach the battery cable
with the clip from the cowl.
( d ) Remove the black-yellow wire of the wiring harness from the
terminal S of the starter switch.
( e ) Pull out the high tension
cord from the ignition coil
and loosen the primary termi-
nal nut of the distributor to
remove the primary line.