Modification; Output Level; Specifications - Tascam XS-4 Owner's Manual

English

3. Modification

3.1. Output level

XS-4 has two MASTER outputs.
MASTER OUTPUT 1 (27): Balanced XLR connectors
MASTER OUTPUT 2 (28): Unbalanced RCA jacks
These output level is set to 0 dBV. These output levels
can be changed to +6dBV with jumpers. (See diagram
below.)
WARNING
Changes on the Output Level have to be performed
by a qualified technician.
NOTE
You must be careful when setting up the nominal
output level of the mixer. The "clip" display of the
connected power amplifiers must never remain
permanently lightened up, but do it occasionally by
following the rhythm of the bass signals that are
being played.
JUMPER PIN
CONFIGURATION.
TOP VIEW
FACTORY ADJUSTED
OUT 1 0dB
0dB
OUT 2 0dB
+6dB
OUT 1 L
8
TASCAM XS-4
OUT 1 R OUT 2 L OUT 2 R
3. Modification

4. Specifications

LINE IN (PGM1-4):
Input Level:
Input impedance:
PHONO IN (PGM1-4)
Input Level:
Input impedance:
MIC INPUT
Input Level:
Input impedance:
EXT INPUT:
Input Level:
Input impedance:
MASTER OUT 1:
Nominal Output Level:
Output impedance:
MASTER OUT 2:
Nominal Output Level:
Output Impedance:
REC OUT:
Nominal Output Level:
Output Impedance:
PHONES:
Frequency Response:
LINE IN:
PHONO IN:
MIC IN:
Signal to Noise Ratio:
LINE IN:
PHONO IN:
MIC IN:
Total Harmonic Distortion:
LINE IN:
PHONO IN:
MIC IN:
EQ
HIGH:
LOW:
Power Requirement:
Power Consumption:
Dimension (mm):
Weight:
All specifications subject to change without notice.
4. Specifications
RCA, unbalanced
-10dBV
50kohm
RCA, unbalanced
-45dBV
50kohm
TRS, balanced
-50dBV ~ -30dBV
1.5kohm
RCA, unbalanced
0dBV
20kohm
XLR, balanced
0dBV
600ohm
RCA, unbalanced
0dBV
1kohm
RCA, unbalanced
0dBV
10kohm
230mW, (at 400ohm)
10Hz to 30KHz, -1.0dB
RIAA, +/-0.5dB
10Hz to 30KHz, -1.0dB
95dB (IHF A WTD)
90dB (IHF A WTD)
75dB (IHF A WTD)
<0.08%
<0.09%
<0.15%
6.5kHz, +10dB ~ -30dB
200Hz , +10dB ~ -30dB
100V-240V(50Hz-60Hz)
22VA
265(W) x 80(H) x 325(D)
3.6kg