Rear Panel; Front Panel - Tascam XS-4 Owner's Manual

2. Features and controls

2.3. Rear Panel

u
MIC INPUT (balanced TRS connector)
Connect the microphone to this connector.
Connections are as follows:
TRS
HOT: Tip
COLD: Ring
GND: Sleeve
NOTE
If you connect the unbalanced microphone to this
connector, we recommend that cold (Pin 3 or Ring)
short-circuited to GND (Pin 1 or Sleeve).
i
ADJ
Adjusts the microphone input signal gain.
NOTE
MIC input sensitivity adjustment must be done by
very carefully using the headphones as a reference
and avoiding that input could be clipped (overload).
o
PHONO INPUTS (unbalanced RCA jacks)
Connect the turntables equipped with the MM cartrige.
p
GND terminal
If the turntables are fitted with grounding wires, connect
these to this GND terminal to reduce noise and hum.
a
LINE INPUTS (unbalanced RCA jacks)
Connect the line level equipment, such as CD players,
cassette decks, DAT, MD, etc.
s
EXT INPUT (unbalanced RCA jacks)
Connect external line level equipment.
The input signals from these jacks are mixed to master
bus (pre MASTER 1/2 control).
d
REC OUTPUT (unbalanced RCA jacks)
Outputs the pre MASTER 1/2 signal.
For example, to connect the recorder to these jacks, you
can record your live performance before MASTER
LEVEL control.
f
MASTER OUTPUT 1 (balanced XLR connector)
Outputs the master output signal adjusted by MASTER 1
control.
Connections are as follows:
HOT: Pin 2
COLD: Pin 3
GND: Pin 1
g
MASTER OUTPUT 2 (unbalanced RCA jacks)
Outputs the master output signal adjusted by MASTER 2
control.
h
POWER switch
j
AC POWER jack

2.4. Front Panel

k
PHONES
Connect your headphone to this jack.
English
7
TASCAM XS-4