Assembly Instructions - Troy-Bilt TB70SS Operator's Manual

On some units, the D-handle may be pre-installed, requiring
only loosening screws and some adjustment. If this is the case,
go to step 4.
INSTALLING AND ADJUSTING THE D-HANDLE
1. Remove the screws and bottom clamp piece that were
installed on the D-handle for shipping.
2. Place D-handle the over the shaft housing and onto the
bottom clamp (Fig. 1). Place it a minimum of 6 inches
(15.24 cm) from the end of the shaft grip.
Shaft Grip (4) Screws
Shaft
Housing
On/Off Stop Control
Minimum 6 inches
(15.24 cm)
D-Handle
Bottom Clamp
3. Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the handle
adjustment.
4. If the D-handle was pre-installed, loosen the screws on the
handle just enough to move it.
5. While holding the unit in the operating position (Fig. 2),
position the D-handle to the location that provides you the
best grip.
6. Tighten the clamp screws evenly, until the D-handle is
secure.

ASSEMBLY INSTRUCTIONS

Fig. 1
Fig. 2
INSTALLING THE CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment shield
on your unit is not installed or if you ever need to re-install it.
WARNING:
Never operate the trimmer without
the cutting attachment shield in place to prevent
serious personal injury.
1. Slide the cutting attachment shield into the shield mount
on the cutting attachment. Align the screw holes in the
shield with the holes in the cutting attachment (Fig. 3).
Shaft Housing
Cutting Attachment
2. Place a hex lock nut into one of the three recessed holes on
the top of the cutting attachment shield (Fig 4).
3. Install a screw into the hole from the bottom of the cutting
attachment shield and screw it into the nut installed in step
2 (Fig 5). Do not tighten.
4. Repeat steps 2 and 3 until all three screws have been
started, then tighten securely.
Cutting Attachment
Shield
Shield Mount
Fig. 3
Cutting Attachment
Shield
Recessed Holes
Hex Lock Nut
Fig. 4
Screws
Fig. 5
5