Table of Contents
Advertisement
P
ROGRAMMING
This section describes how to set the scanner's programmable features.
These features can be configured using the barcode labels contained in
this manual or by using commands sent from the host. Refer to Appendix
B, Additional Information, for host programming details. If you program
the scanner using these barcodes, the scanner stores the changes until
reprogrammed. Whenever you use these labels to change programmable
features, you are changing these features for the active interface only.
W
I
P
HAT
S
ROGRAMMING
To change the scanner's programmed settings, it is necessary to place the
scanner in Programming Mode using the special "set" label. This ensures
that the scanner only recognizes the special programming labels contained
in this programming guide.
H
T
P
OW
O
ROGRAM
The following pages contain special barcode labels that are used to
change or enable the scanner's programmable options. All programming
sessions follow this order, unless otherwise instructed:
Programming should be performed with the
base station in near proximity to ensure opti-
mal communication and sllow the user to
monitor the base station's LED indicators.
1. Scan the SET label at the top of the page. The scanner will
emit two beeps indicating it has read the label, and the base
station's red LED will begin flashing. As long as the lamp is
flashing, the scanner will only recognize and decode pro-
gramming labels.
2. Scan the feature label(s) for the programmable options
you wish to enable. The scanner will emit two beeps each
time you scan a valid label. (Note that not all features are
available for all interfaces.) The first beep indicates that the
scanner has read the label, the second announces base station
acknowledgement of the label.
3. Scan the END label at the bottom of the page to complete
the programming session and exit Programming Mode.
4
O
VERVIEW
M
?
ODE
U
B
SING
ARCODES
NOTE
SP400RF Programming Guide
Advertisement
Table of Contents
