Table of Contents
Advertisement
Available languages
Available languages
Problems
Solutions
TV CHANNELS
Check your auto lock function's settings inside the OSD. You may have locked
ARE BLOCKED
up some channels but forgot about them.
UNIVERSAL
This TV follows NEC's universal remote code. Please check your hand book
REMOTE CODE
for NEC's codes then apply them.
THE TV TURNS
This TV is a High Definition liquid crystal display panel TV. It requires a few
ON OR OFF
more seconds than normal TVs to power up and show the picture.
SLOWLY AND
THE SCREEN
SHOWS UP
SLOWLY
NO SOUND ON
Make sure you have a 3.5 mm mini-jack cable connected from your pc's sound
PC
output to the TV's VGA STEREO INPUT.
HDCP
VIDEO
Reboot your HDCP video device but turning them off and unplugging the power
SAYS NO HDCP
cord. Wait up to 8 minutes to plug the power back in to see if it works or not.
SUPPORT
Make sure you have a 3.5 mm mini-jack cable connected from your HDCP video
HDCP
VIDEO
device's sound output to the TV's VGA STEREO INPUT. If your HDCP video
HAS NO AUDIO
device uses RCA AUDIO jacks, you'll need to obtain a RCA audio converted
into 3.5 mm mini-jack cable.
CANNOT
GET
Make sure the TV is recognized as plug and play monitor. Try updating your
1360X768 ON PC
video card's drivers as well. If that does not help, most likely you'll need to
VGA
upgrade your video card to a newer one.
PICTURE
IS
This might be from interference from large electrical appliances, cars,
DISTORTED
OR
motorcycles, or fluorescent lights. If the TV is close to the wall, try moving the
HAS ABNORMAL
TV to another room in your house to see if the problem still occurs.
SOUND
If you're using HDMI or a TV digital channel make sure you use the ASPECT
button to switch to 16:9 format.
ADJUST function to adjust to the screen. Please Note : If you are using regular
PICTURE
DOES
analog TV, AV, or component in 480i resolution, use the ASPECT button to
NOT COVER THE
switch to 16:9 in order to fill up the screen. Please Note : This note this feature
ENTIRE SCREEN
will distort the picture.
If you are using VGA, use the AUTO
28
Hide quick links:
Advertisement
Table of Contents
