Xbox 360 Hdmi Setup - Plantronics RIG User Manual

Xbox 360 HDMI setup*

*Some components sold separately.
1 Make sure the boom microphone is attached properly to the headset. Insert the 3.5mm plug
into the headset jack on the front of the mixer located under the RIG logo tab, on the left side.
2 Connect the USB cable from the mixer into a USB port on the Xbox 360 (For proper function:
make sure that the USB connector is plugged into the Xbox 360 itself and not an external USB
power source. .
3 Attach the included 3.5mm-to-RCA Piggy back adapter to the end of the long 3.5 mm plug cable.
• Option 1: Attach the RCA Piggyback to the AV HDMI adapter. This adapter is not included and is
sold separately by Microsoft and other manufacturers. Plantronics does not supply this
component. Attach the AV HDMI adapter into the Xbox 360.
• Option 2: Alternatively, if your TV or AV Receiver has an available RCA audio out or a 3.5mm
headphone feature, connect the audio cable directly to your TV. You may need to change the
audio settings of your TV to pass audio through to an external device and turn off the TV
speaker. Note that the USB cable must still be connected to the Xbox 360 for power.
4 Insert the included Xbox Live chat cable into the 2.5mm jack (smaller of the two) located to the
right of the headset jack on front of the mixer. Insert the other end to your Xbox game
controller. For best performance, use the connector with the 90 degree angled plug attached to
the Xbox 360 controller and the straight plug connected to the mixer.
5 Find a good balance of game and voice audio by adjusting the Game/chat sound balancer on the
right side of the mixer (over the orange LEDs). Remember that the 3 o'clock position will enable
equal volume of both game and voice audio signal. Sliding the control
sound louder and voice (game chat) quieter. Sliding the control
chat) while making game audio quieter.
HDMI
upward makes game
downward increases voice (game
12