Pitch Control - Technics SL-P1300 Operating Instructions Manual

I Auto cue function
1 (automatic standby)
v indicator
m indicator
At the beginning of each track on most discs, a silent interval of
about one second is recorded. Therefore, when play is started
from 0 minute 00 second, music is not heard immediately.
When the auto cue function is activated, the unit automatically
detects the beginning of the music on each track and then
switches to the standby mode.
When play is started from this point (by pressing the play button),
music is heard immediately.
1
Press the auto cue button (I-=).
The auto cue indicator above the button and the m
indicator on the display panel illuminate.
2
Press the play button.
Them indicator on the display panel illuminates and the
unit swtches to the standby mode.
3
Press the play button again.
Play begins immediately.
The-indicator goes out.
In this mode, the unit switches to standby at the beginning of
each track. It is therefore necessary to press the play button to
resume play at the beginning of every track.
Display of the actual point at which play begins.
To cancel the auto cue function
n Press the auto cue button again (=-1).
Notes:
*If the auto cue button is pressed during play. this function is
activated at the beginning of the next track.
*The auto-cue function may not work properly if a selection
begins with a very soft passage or if there is a lot of background
"OISC?
Pitch control
This function allows fine adjustment of pitch (up to approx.
28%).
1
Press the pitch control button "on".
The pitch control indicator illuminates.
2
Slide the pitch control knob upward or
downward to the desired setting.
In the center position (D), a "click" can be perceived. This
position is the 0% standard pitch.
Notes:
*When the pitch has been changed, the elapsed or
remaining playing time readings differ from the actual
times by the amount of pitch adjustment.
elf this unit is connected to a dedicated D/A converter or a
digital amplifier equipped with a built-in D/A converter
using the digital output terminal. setting the pitch control
switch to the ON position to enable pitch control can cause
the output to become inaudible with certain digital equip-
ment.
Please check to make sure that normal audio output is
obtained.
To cancel the pitch control function
H Press the pitch control button again.