Definitions - Samsung SHS-3420 User Manual

Definitions

|
Double Authentication Mode :
ensuring more security. However, Master PIN Code can open the door regardless of mode. This mode is
disabled by default.
Double-locking :
Double-locking prevents the lock from being unlocked from the outside. You can enable
it by using the Double lock lever.
Emergency Power Supply :
lead to the batteries discharging and cause the lock to malfunction. You can open the door by touching the
external power contacts on the Exterior Unit with a 9V battery and then touching with the Card or entering
the PIN Code.
Indicator Lamp :
Indicates the operational status when the Card is being read or the lock is in operation.
Infrared Ray Sensor :
opens by pressing [Open/Close] button. It prevents the door being opened by abnormal methods. You can
enable or disable this sensor. This sensor is disabled by default.
Intrusion Detection Function :
detected by the magnetic sensor and an alarm is sounded. (The function is not activated when the magnet is
not used.)The Intrusion Detection function is a basic function and cannot be enabled or disabled.
Locking Mode (Auto/Manual) :
when it is closed. The factory default is 'Auto mode'.
- Auto: The door is locked automatically 2 seconds after it is closed. However, it does not function if the mag-
net is not used or the batteries are completely discharged.
- Manual: When the door does not lock automatically when it is closed, pressing the [Wake-Up] button or the
[OPEN/CLOSE] button on the Interior Unit will lock the door.
Refers to the state when the operating voltage of the lock is lower than the standard voltage,
Low Voltage :
and activates the Low Voltage Alarm ("Fur Elise") to indicate that the batteries need to be replaced. Use the
Emergency Power when the batteries are completely discharged.
Magnetic Sensor :
Detects the opening and closing of the door.
Malfunction Prevention Function (Mischief Prevention Function) :
thentication attempts with unregistered PIN Codes/Cards occur, a warning sounds for 10 seconds, and the
lock stops operating for 3 minutes. While lock operation is stopped, a 'beep' is sounded every 10 seconds
and the lock is activated again automatically after 3 minutes. The Malfunction Prevention function is a basic
function and cannot be enabled or disabled.
Manual Switchgear :
lock or unlock the door from inside.
Master PIN Code :
You can enter only one Master PIN (4-12 digits) Code. You can register the User PIN
Codes/Cards after authenticating with the Master PIN (4-12 digits) Code. You can open the door with the
Master PIN Code, and the factory default is '1234'.
OPEN/CLOSE Button :
inside in the Manual locking mode.)
Out-of-Home Security Function :
Pressing the [OPEN/CLOSE] button while the Out-of-Home function is enabled sounds an alarm. You can
enable this function with either the Master PIN code or the User PIN Codes.
Random Security Function :
Code after authenticating 2 arbitrarily selected numbers. When the buttons for 2 arbitrarily selected numbers
are illuminated, pressing the 2 illuminated buttons illuminates the whole number pad. You can enable or dis-
able the Random Security function. This function is enabled by default.
This mode requires both User Card and PIN Code to open the door,
Double-locking enable
Continuing to use the lock without replacing batteries when required will
This sensor detects movement on the inside with an infrared ray when the door
When the Interior Unit is forcibly detached while the door is locked, it is
You can enable or disable the function for locking the door automatically
When the batteries are completely discharged, this device is used to mechanically
A one-touch button to open the locked door. (It is also used to lock the door from
This function prevents intrusions from outside when no one is home.
This mode prevents the disclosure of the PIN Code by entering the PIN
Double-locking disable
11
When more than 5 failed au-