Yeti Communications Huracan HR-07-NZ Owner's Manual page 4

TRANSMITTER
Power Output (Max):
Modulation: AM = Class B Amplitude.
FM = 2.5Khz @ 20mV 1Khz Audio in Spurious Emission -60dB
AF Modulation Response AM / FM 450 – 2500 Hz
RECEIVER
Circuit Type : Dual-Conversion Superheterodyne
Intermediate Frequencies :
Sensitivity :
SSB ...................................................0.25 μV at 10 dB S + N/N
AM ....................................................1.0 μV at 10 dB S + N/N
FM.....................................................0.3 μV at 12 dB SINAD
Selectivity :
SSB .................................4.2 kHz (-6 dB) / 8.5 kHz (-60 dB)
AM / FM ........................................... 6.0 kHz (-6 dB) / 18 kHz (-60 dB)
IF Frequencies AM/FM 1st 10.695Mhz, 2nd 455Khz.SSB 10.695Mhz
Adjacent Channel Rejection : Better than 70 dB
IF Rejection : Better than 80 dB for all frequencies
Automatic Gain Control (AGC): Less than 10dB change in audio output for inputs From 10 V to
50,000 V.
Squelch/ RF Gain Controls: 0.5 V=0dB Center Ref. adjustable +3dB to –40dB From threshold at
rated sensitivity adjustable at Full mute 25 V at Max Gain, 1mV at Min. Gain.
ANL+NB: RF Type ANL @3dB + NB @12dB
Clarifier Range : Fine: 1.5Khz Rx/Tx
Audio Output: 4W Max., 3W @10% THD with 8 Ohms Load.
Audio Response: 450-2500Hz.
External PA Output: 4W at 8 Ohms, disables internal speaker while plugged-in.
AM 10w Carrier/50W PEP
FM 50W
SSB 50W PEP
1st IF / SSB IF ........ 10.695 MHz
2nd IF ........................ 455 kHz