Rear Panel Details - Yeti Communications Huracan HR-07-NZ Owner's Manual

REAR PANEL DETAILS:

1: 50 ohm antenna input SO239 Socket:
2: DC Power Input (13.8 volts dc)
3. Public Address (PA) Horn Jack
A PA horn jack is located on the rear panel of the transceiver.
The Huracan HR-07-NZ is designed to accept any standard PA horn for use with
two-way transceivers. To operate in PA mode, please refer to the previous
instructions.
4. External Speaker Jack
An external speaker jack is located on the rear panel of the transceiver. The
Huracan HR-07-NZ is designed to accept any standard 8 ohm external speaker
for use with two way transceivers.
IMPORTANT NOTE FOR USE EXTERNAL
The external speaker jack " EXT. SPK. " on the rear panel, is used for remote receiver monitoring.
The external speaker should have 8 ohms impedance and be able to handle at least 4 watts.
When the external speaker is plugged in, the internal speaker is disconnected.
IT HAS NO AUDIO OUTPUT FROM THIS JACK, WHILE SELECTED TO P.A.MODE
OPERATION.
SPEAKERR1