Assigning Address To Indoor Unit - Samsung MHXXXFJEA Series Installation Manual

Assigning address to indoor unit

16
E-
FJM CONSOLE_IM_29317A_E_10.16.08.indd 16
1
Before installing the indoor unit, assign an address to the indoor unit
according to the air conditioning system plan.
2
The address of the indoor unit is assigned by adjusting MAIN(SW02) and
RMC(SW04) rotary switches.
SW05 SW06
3
It is required to set the RMC address if you install the wired remote control
and/or the centralized control.
4
If you install optional accessories such as the wired remote control, centralized
control, etc. see an appropriate installation manual.
5
If an optional accessory is not installed, you do not have to set the RMC address.
However, adjust K1 and K2 switches of the SW05 DIP switch to "ON" position in
this case.
6
Set the MAIN address by adjusting the rotary switch(SW02) from 0 to F.
Each indoor unit connected to the same outdoor unit must have different
address.
If an indoor unit does not have an optional accessory and its MAIN address is "0"
SW04 RMC SW02 MAIN
SW07 SW04 RMC SW02 MAIN
Extra
controller
SW05 SW06 SW07
2008-11-24 15:41:38