Installing the IR Extender
IR (infrared) Extender allows you to install your
set-top in an inconspicuous location, such as on a bookcase
or inside a cabinet, and control the set-top with your remote
MADE IN MEXICO
MCARD SN: PXCPRPSLV
MCARD MAC: 00 1BD73E17D9
MULTI-STREAM CABLE CARD
THIS DEVICE IS INTENDED TO BE ATTACHED TO A RECEIVER THAT
IS NOT USED TO RECEIVE OVER-THE-AIR-BROADCAST SIGNALS.
CONNECTION OF THIS DEVICE IN ANY OTHER FASHION MAY CAUSE
HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS AND IS IN
VIOLATION OF THE FCC RULES, PART 15.
Plug the connector into the IR port on the back of
Peel the paper backing from the adhesive pad
on the bottom of the receiver. Then, mount the
IR Extender receiver in an inconspicuous place,
but make certain that nothing blocks the sensor
on the front of the receiver.
To control the set-top, press the keys on the
remote control while aiming the remote control at
the sensor on the receiver.
Note: If you encounter problems, make sure that all
connections are secure and that nothing blocks the
path between the receiver and your remote control.
For further assistance, contact your service provider.
Important: Do not block the sensor on the
front of the receiver, or you cannot control the
set-top with your remote control.
Place the sensor away from compact
ﬂ uorescent light, plasma TV displays, or LCD
HDTVs. The sensor signal may be blocked
when placed too close to these types of
devices, and the remote control will no longer
CAUTION: If installing the set-top in an enclosed
area, such as a bookcase or cabinet, provide
proper ventilation to prevent damage to the set-top.
See the user guide that came with your set-top for
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR
120 V ~