Installation - One for All SV-1710 User Manual

See page 3 (fold-out page)
Before starting the installation make sure that both the
1
TRANSMITTER and RECEIVER are switched off.
TRANSMITTER
OFF
Connecting the TRANSMITTER
2
Use the cable labeled "TRANSMITTER". Connect the RCA-plugs (Red,
White and Yellow) to the corresponding connectors of the
TRANSMITTER unit. Connect the SCART connector to the device that
you select for supplying the picture (source device). Make sure that
the SCART is connected to the correct Output of the device,
normally called "Line Out".
If you wish to remotely control the source device (satellite receiver, video
recorder, camcorder, DVD player, digital or analogue Set-Top Box or Pay-TV
decoder box) from another room, for example to change channels on your
satellite receiver, you will need to either:
Place the TRANSMITTER on top of the source device. Make sure that
A
the front side of the TRANSMITTER is aligned with the front side of
the source device.
OR
Place the TRANSMITTER next/close to the source device and connect
B
the IR eye to the TRANSMITTER. Place the IR eye directly on the IR
receiver window on the front-side of the source device OR in front
of the source device (make sure there is no interference of the IR
Eye signal going to the IR receiver of the source device).
Now, insert the adapter plug into the connector on the backside.
Connecting the RECEIVER
3
Use the cable labeled "RECEIVER". Connect the RCA-plugs (Red,
White and Yellow) to the corresponding connectors of the RECEIVER
unit. Connect the SCART connector to the device you selected for
displaying the picture (destination). Make sure that the SCART is
connected to the correct Input of the device, normally called
"Line In".
Insert the adapter plug into the connector on the backside.
If you want to control the source device, place the RECEIVER on top or
beside the destination device where it is able to catch the IR command
from your remote control.
6

Installation

RECEIVER
OFF
OFF
WWW.ONEFORALL.COM
ON