Toshiba e-STUDIO2500c Service Manual page 383

(3) Remove 1 clip on the front side.
(4) Remove 2 bushings and take off the upper
transport roller.
[K] Middle transport roller
(1) Take off the ADU drive unit.
P.16-17 "[I] ADU drive unit / ADU motor
(M22)"
Remove 2 clips, 2 pulleys and 2 pins on the
front side. Then take off the timing belt.
(2) Remove 2 clips, 2 pulleys and 2 pins on the
front side. Then take off the belt.
(3) Remove 1 E-ring, 1 clip and 1 bushing on the
rear side.
(4) Take off 1 bushing on the front side. Then
take off the middle transport roller.
May 2006 © TOSHIBA TEC
Upper transport roller
Bushing
Fig. 16-25
Belt
Pin
Pulley
Fig. 16-26
E-ring
Clip
Bushing
Fig. 16-27
e-STUDIO2500c/3500c/3510c AUTOMATIC DUPLEXING UNIT (ADU)
16 - 19
Clip
Bushing
Pin
Pulley
Clip
Clip
Middle transport roller
Bushing
16