Toshiba e-STUDIO2500c Service Manual page 209

[A-9] Bypass feed roller
(1) Take off the bypass upper guide.
P.10-18 "[A-5] Bypass upper guide"
(2) Remove the clip and take off the bypass feed
roller.
Notes:
Make sure the following items when assem-
bling the bypass feed roller.
1. Set the timing belt to the pulley securely.
2. Do not put the wrong position when set-
ting the timing belt.
3. Be sure to insert the clip into the groove
of shaft.
4. Check that there is no stain such as oil on
the surface of timing belt, the pulley and
the roller.
5. Install the bypass pickup roller and the
bypass feed roller in the correct direction.
[A-10] Bypass transport roller
(1) Take off the bypass upper guide.
P.10-18 "[A-5] Bypass upper guide"
(2) Remove the E-ring, pull out the shaft and
take off the bypass transport roller.
May 2006 © TOSHIBA TEC
Bypass feed roller
Fig. 10-28
E-ring
Bushing
Fig. 10-29
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
10 - 21
Clip
Bushing
Bypass transport roller
10