Setup; Loose Parts; Installing The Drive Wheels; Checking The Tire Pressure - Toro Z286E Operator's Manual

Setup

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
Description
Rear Wheels
Control lever–right
Control lever–left
Bolt 3/8 x 1 in.
Spring washer 3/8 in.
Suspension Seat
Nuts
Air Filter
Hose Clamp
Key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card

Installing the Drive Wheels

1. Uncrate mower.
2. Remove wheel nuts from rear wheel hubs.
3. Align holes. Mount drive wheels with the valve stem
to the outside of the traction unit.
4. Secure using wheel nuts provided. Torque to 95 ft-lbs
(128 N M).
Important Make sure that wheel nuts are torqued to
95ft–lbs (128 N M).

Checking the Tire Pressure

Check the air pressure in the front and rear tires (Fig. 2).
Pressure: 13 psi (90 kPa)
Qty. Use
2 Installing the wheels to traction unit
1
1

Installing the motion control levers

4
4
1
Installing the seat
4
1
Installing the air filter
1
2
1 Read before operating machine
1 Read before operating machine
1
1 Fill out and return to Toro
1. Valve stem
Installing the Motion Control
Levers
There are two positions to install the control levers: high
and low. Install levers in the top and middle holes for the
high position. Install levers in the middle and bottom
holes for the low position.
1. Remove the 4 bolts (3/8 x 1 in.) and 4 spring washers
(3/8 in.) which attach the motion control levers to the
control arm shafts for shipping (Fig. 3).
14
1
m–1872
Figure 2