Toro Z286E Operator's Manual page 25

2. Remove bracket pin (Fig. 15).
2
5
1
3
Figure 15
1. Z Stand
2. Latch
3. Bracket
1
2
Figure 16
1. Z Stand (Positioned in
slot)
3. Raise latch. Swing stand foot out front and slide stand
toward machine, into the bottom of slot
(Fig. 15 and 16).
4. Set foot of stand on the ground and rest latch on pivot
tab (Fig. 16).
5. Start engine and put at half throttle.
Note: For best results, place foot of stand into seams in
sidewalks or into turf (Fig. 16).
6. Drive onto stand. Stop when latch drops over tab into
locked position (Fig. 16). Once onto stand, engage
parking brake. Shut off engine.
7. Chock or block the drive wheels.
Warning
Parking brake may not hold machine parked on
Z Stand and could cause personal injury or
property damage.
Do not park on Z Stand unless wheels are chocked
or blocked.
4
m–5599
4. Bracket Pin
5. Bottom of slot
3
m–5600
2. Crack in side walk or turf
3. Latch resting on pivot tab
25
8. Perform maintenance.
9. Remove chocks or blocks.
Driving off the Z Stand
1. Raise latch to unlocked position (Fig. 17).
2. Start engine and place at half throttle. Disengage
parking brake.
3. Slowly drive backwards off of stand.
4. Return stand to its rest position (Fig. 15).
4
2
1
Figure 17
1. Z Stand
2. Latch
3
m–5601
3. Locked position
4. Unlocked position